TIME RINSTALLATION& OPERATINGINSTRUCTIONS
To Set Timer (dual timer mode)8In the dual timer mode setting you canprogram your Timer to come “ON” daily,Mon thru Fri, Mon thru Sat or Mon thruSun.
STEP 5 Press & Hold “Timer”.(Green light will remain on & “T2” willflash.)STEP 6 Press “ ” or “ ” to set “ON” time.STEP 7 Press “Day” to set d
Manual & Timed Heater OperationThe “Manual” button is used to turn the heateron and off when desired.STEP 1Press “Manual” to activate the heater.
DiagnosticsWhen the Timer is installed on a PROHEATheater, the Timer's red 'Heater activatedlight' will be lit constantly while the hea
12
SeaStar Solutions warrants the Timer to be free from defectsin material and workmanship under normal use and service fortwo (2) years on parts and one
SeaStar Solutions3831 No.6 RoadRichmond, BCCanada V6V 1P6Tel: (604) 270-6899Fax: (604) 270-7172© 1993 Marine Canada Acquisition Inc.DBA SEASTAR SOLUTI
General DescriptionDAY OFTHE WEEKTIME AM INDICATORT2 PROGRAMINDICATORT1 PROGRAMINDICATORCLOCKTIME RETARDTIME ADVANCEDAY ADVANCETIMERACTIVATEDLIGHT (GR
The 7 Day Digital Timer can be preset for asingle start time, one day at a time or twoprogrammed start times per day constantlyactivated for multiple
InstallationDash Surface MountSTEP 1 Drill 3/4" diameter hole in centreof mounting area for connecting wires.STEP 2 Use self adhesive strips to a
Below DashGauge HoleWASHERNUTBRACKETSELF TAPPINGSCREW, USEDRILL #25 (.149" DIA.)STUDDASHTIMERWASHERNUTBRACKETSTUDSTANDARD 2 1/8" DIAGAUGE HO
Wiring & Dip Switch SettingsON2 314TIMERRED WIRE (power)BLACK WIRE (ground)GREY WIRE (keyswitchbacklighting optional)GREEN WIRE(“ON” signal to hea
PROHEAT Heater ConnectionCAUTION: Power to the controller must be dis-connected before connecting the Timer.Connect the heater switch harness wiresto
STEP 1 Press & Hold “Clock”.STEP 2 Press “ ” or “ ” to set time.STEP 3 Press “Day” to set day.STEP 4 Release “Clock”.NOTE: 12 or 24 hour option is
To Set Timer (single timer mode)STEP 1 Press & Hold “Timer”.(Green light will go on & “T1” will flash.)STEP 2 Press “ ” or “ ” to set “ON” tim
Comments to this Manuals